XPSMCCPC Schneider Electric Software Licence

XPS MCWIN, Configuration Software_x000D_ 30 certified safety functions are available with this software and they are easily assignable to the safety outputs. The safety functions have multiple combination possibilities and various starting conditions. The safety functions are certified in accordance with EN 954-1/ISO 13849-1 and IEC 61508. All 8 safety outputs are suitable for use in safety related parts of control systems conforming to category 4 of EN 954-1/ISO 13849-1 and each output can disconnect one of its safety circuits. The main safety functions are as follows:_x000D_ Emergency stop monitoring, with or without time delay, 1 or 2-channel wiring_x000D_ Two-hand control (type III-C conforming to EN 574-1)_x000D_ Guard monitoring with 1 or 2 limit switches, with or without locking_x000D_ Guard monitoring for injection presses and blowing machines_x000D_ Coded magnetic switch monitoring_x000D_ Safety mat monitoring_x000D_ Light curtain monitoring, solid-state and relay output types_x000D_ Zero speed detection_x000D_ Dynamic monitoring of hydraulic valves on linear and eccentric presses_x000D_ Monitoring safety stop at top dead centre on eccentric press_x000D_ Safety time delays_x000D_ “Muting” function for light curtains_x000D_ Enabling switch monitoring, 2 or 3 contact_x000D_ Logic OR function_x000D_ Foot switch monitoring_x000D_ Chain shaft breakage monitoring_x000D_ Hydraulic and eccentric press monitoring_x000D_ Position selector_x000D_ Note_x000D_ To connect XPS-MC to a PC for programming and diagnostic purposes:_x000D_ Laptop PC with 9 pin serial port: use RS 382-2645 and 544-490_x000D_ Laptop PC with USB port: use RS 464-962 and RS 218-080